Configuring Dial Security Remotely 11-93 If Dialback is enabled at the host CourierV.Everything modem’s site, setyour modem to answer the host CourierV.Everything modem when itdials back.4 Call the host.5 After the call ends you can disable Auto Answer.Configuring DialSecurity RemotelyThe host administrator can configure the host’s security settings remotely.At the host device, you must have previously enabled remote access andassigned a remote-access password that allows view-and-changeprivileges (see Chapter 9, Accessing and Configuring the CourierV.Everything modem remotely). You may want to use your administrativepassword as your remote-access password.Dialing In From the Remote Site1 From the remote site, connect to the host using Dial Security. Once aconnection is made, follow the instructions for beginning aremote-access session as described in Chapter 9, Accessing anConfiguring the Courier V.Everything modem remotel .2 When remote access has been granted, use the AT%S= command taccess the Dial Security accounts. See Maintaining Security Accountssection earlier in this chapter.To view the security account information use ATI10.3 Make any configuration changes and execute them immediately byentering AT%C2.4 To end the remote session and reactivate Dial Security on the host, resetthe host device by issuing ATZ.For your modem to be set CommandTo answer the Dialback call ATS0=1For your modem to CommandDisable Auto Answer ATS0=0
