74 A PPENDIX B: D YNAMICAccess S OFTWARE I NSTALLATION AND C ONFIGURATIONInstalling DynamicAccess SoftwareTo install DynamicAccess software:1 Make sure that the NIC and its software are installedon your PC.See “Verifying Successful Installation” in Chapter 3 toconfirm that the NIC is properly installed in the PC.2 Start Windows.3 Double-click the DAINST.EXE file on your hard drive.This file is automatically copied to your hard drive duringthe NIC driver installation into the following directory:n Windows 95/98 — C:\WINDOWS\SYSTEMn Windows NT 4.0 — C:\WINNT\SYSTEM32n Windows NT 3.51 — C:\WINNT35\SYSTEM32If you cannot locate the file on your hard drive, copy thefile from EtherDisk diskette 2 to the appropriate directory.The file is expanded and the DynamicAccess software isinstalled on your PC.4 Restart the PC.You must restart the PC to complete the installation.Table 12 DynamicAccess Software Minimum Client RequirementsOperatingSystem PC RequirementsRecommendedMicrosoft Service PackWindows 95 486/75 MHz CPU16 MB RAM (32 MB recommended)5 MB available hard drive spaceWindows 95 OSR2 orService Pack 1Windows 98 486/75 MHz CPU16 MB RAM (32 MB recommended)5 MB available hard drive spaceNoneWindows NT 4.0 Pentium/100 MHz CPU32 MB RAM5 MB available hard drive spaceService Pack 3Windows NT 3.51 Pentium/100 MHz CPU32 MB RAM5 MB available hard drive spaceService Pack 5
