Changing NetWare Driver Configuration Parameters 1032 Log in or map to the server.If you cannot log in or map to the server, the link isnot functional.If the link is functional, the following message appears:Link integrity test for primaryslot #XXXXX passed.Changing NetWare Driver Configuration ParametersYou can change server configuration parameters usingthe NetWare installation program Configuration screen.The following table lists the parameters shown on theConfiguration screen. Default values are shown inuppercase text.Table 2 NetWare Installation Program Configuration ParametersParameter Range of Values DescriptionSlot Number All PCI slot numbers validto the systemRepresents the PCI slot number ofthe physical NIC to be configured.Node Address Default is factory-assignedMAC address.Leave blank to usefactory-assigned default.ENABLE_CHKSUM EnableDISABLENetWare 5.0 only. Enter theparameter on the load line toenable TCP/IP checksum offload.Do not enable TCP/IP checksumoffload if you plan to form loadbalancing/failover groups.SHD_LEVEL NoneBasicENHANCEDBasic + EnhancedBasic—Monitors levels for thefollowing self-healing driverconditions: firmware heartbeat,interrupt availability, recoverabletransmit and receive errors (CRC,transmit underruns, receiveoverruns, collisions, jabbers).Enhanced—Monitors DMA stallsand hardware errors.VERBOSE EnableDISABLEEnables driver warning and errormessages.
