3Com HomeConnect 3CP3647 Cli User's Manual

Also see for HomeConnect 3CP3647: Installation guide

Contents

A-18 APPENDIX A: CLI C OMMAND DESCRIPTIONOUTPUT COUNTERSn Octets - bytes transmittedn Ucast - unicast packets transmittedn MultiCast - multicast packets transmittedn Discards - Number of outbound packets which were chosen to be discardedeven though no errors had been detected to prevent their being transmitted.One possible reason for discarding such a packet could be to free up bufferspace.n Errors - For packet-oriented interfaces, the number of outbound packets thatcould not be transmitted because of errors. For character-oriented orfixed-length interfaces, the number of outbound transmission units that couldnot be transmitted because of errors.n Out QLen - length of the output packet queue (in packets)show ethernet settings Displays settings for the ethernet interface.show ip settings Displays system wide IP information.n IP System Host Address - IP address of the systemn IP Forwarding – always DISABLEDn WAN to WAN Forwarding – indicates if forwarding between WAN Bridgeports is allowed.show memory Displays System RAM Memory usage.n Total System Memory Resources - total amount of memory in systemn Free Memory - amount of memory not in usen Code Size - amount of memory used by coden Initialized Data Size, Uninitialized Data Size, Stack Size - static data areasshow port number> settingsDisplays the parameters defined for the specified VC. You can use list vc to seewhich virtual channels are defined.show security_optionsettingsDisplays status for SNMP User Access and Administration by Remote Users. Youcan modify the SNMP User Access using the enable or disable security_optionsnmp commands. You can modify Administration by Remote User using theenable or disable security_option remote_user commands.n SNMP User Access - ENABLED (default) or DISABLEDn Administration by Remote User - ON or OFFshow snmp counters Displays many SNMP statistics.INPUT COUNTERSn Packets - number of SNMP packets received