Installing the 56K LAN Modem 29Back Panel ConnectorDescriptionThe back panel provides the following components.Figure 10 56K LAN Modem Back PanelFrom left to right the back panel consists of the following.n Power: Connect the power module cable to this port.n Reset: Press this button to re-initialize the unit.n Line: Connect the provided RJ-11 analog line from the wall outlet to this port.n Phone: Connect an external analog device, such as a telephone or faxmachine, to this port.n Four 10BASE-T Ethernet Ports: Connect the computers on your LAN, or anexternal hub, to these ports.Installing the 56K LANModemThis section describes how to do the following.n Install the analog cablen Connect to a 10BASE-T Ethernet LANn Install analog equipmentn Install the power cableBefore You Begin Before you begin, you will need the following in addition to the 56K LAN Modem:n RJ-11 (6-pin) to RJ-11 (6-pin) telephone cable which was provided in yourmodem package.Coll Amber Ethernet Collision Status. Flashes amber when some collisionsare taking place on the Ethernet LAN.Off indicates that no collisions are taking place on the EthernetLAN.Ports 1-4 Green Ethernet LAN Port Status. On indicates that the unit detects theEthernet link integrity signal from an attached computer andoperation is normal.Flashes when the LAN Modem receives data on the associatedport.Off indicates the unit does not detect the Ethernet link integritysignal. The Ethernet cable may not be properly connected or thecable may be the wrong polarity.Table 4 Front Panel LED Indicator Definitions (continued)LED Color DescriptionRESET10-18 VDC0.8 A MAX LINE PHONE LANPowerConnector Reset Button Four Ethernet10BASE-T Connectors4 3 12TelephoneLineAnalogDevice
