Chapter 2. CLI Syntax Reference97 3ware SAS/SATA RAID Controller CLI Guide, Version 9.5.1Port Object CommandsPort Object Messages are commands that provide information and performactions related to a specific disk, attached to a port (or virtual port), such as /c0/p0. You use port object commands for such tasks as seeing the status,model, or serial number of the drive.Note that all refernces to “port” also apply to “VPort” for the commands inthis section.Syntax/cx/px show/cx/px show attribute [attribute ...] where attributes are:capacity|firmware|identify (9000 series SX/SE/SA only)|lspeed (9000 series SX/SE/SA only)|model|ncq (9000 series SX/SE/SA only)|serial|smart|status|identify (9000 series SX/SE/SA only)|driveinfo (9690SA only)dpmstat type=instr|ra|lct|histdata|ext(9000 series SX/SE/SA, except for type=ext, which is SE/SA only)/cx/px show all/cx/px remove [noscan][quiet]/cx/px set identify=on|off (9000 series SX/SE/SA only)/cx/px showThis command shows summary information about the specified disk attachedto port /cx/px.Example for 9650SE and earlier controllers://localhost> /c1/p5 showPort Status Unit Size Blocks Serial---------------------------------------------------------p5 OK u0 149.05 GB 312581808 3JS0L9QWThe above output indicates that port 5 of controller 1 is attached to one diskwith status OK participating in unit 0.Example for 9690SA controller:Note that in this case the summary information is in a slightly different format//localhost> /c3/p1 showVPort Status Unit Size Type Phy Encl-Slot Model--------------------------------------------------------------------------p1 OK u0 149.05 GB SATA 0 - WDC WD1600JS-22NCB1a
