Chapter 2. CLI Syntax Reference115 3ware SAS/SATA RAID Controller CLI Guide, Version 9.5.1/cx/ex showattribute [attribute ...]This command is used with the 9690SA controller. For the 9650SE and CCUenclosure, simply drop the prepended controller name in the command anduse /ex.This command shows the current setting of the given attribute(s). One ormany attributes can be requested. An invalid attribute will terminate the loop.Possible attributes are: controllers, slots, fans, temp, and pwrs (power supply)./cx/ex show controllersThis command is used with the 9690SA controller. For the 9650SE and CCUenclosure, simply drop the prepended controller name in the command anduse /ex.This command lists the controller associated with enclosure /cx/ex.Example://localhost> c0/e0 show controllersc0/e0 connects to /c0 controller/cx/ex/ show diag=helptextThis command is used with the 9690SA controller. For the 9650SE and CCUenclosure, simply drop the prepended controller name in the command anduse /ex.This command allows you to view the enclosure diagnostic log. What isreported by this log will vary depending upon the manufacturer of theenclosure.The enclosure diagnostic log may be requested by 3ware CustomerSupport to help troubleshoot problems on your controller./cx/ex show slotsThis command is used with the 9690SA controller. For the 9650SE and CCUenclosure, simply drop the prepended controller name in the command anduse /ex.This command reports the slots in enclosure /cx/ex and their associatedinformation.Example://localhost> c0/e0 show slotsSlot Status (V)Port Identify----------------------------------------------------slot0 OK /c0/p0 Noslot1 OK /c0/p1 Yesslot2 NO-DEVICE - Noslot3 NO-DEVICE - No
