Chapter 12. Troubleshooting236 3ware Serial ATA RAID Controller User Guide0036 Verify fixed data/parity mismatchThis message is sent by the controller when a verify error is found (parityinconsistency for RAID 5/50 or data mismatch for RAID 1/10 configuration)and recovered. If the error is not recovered the message Verify Failed isreturned instead.0037 SO-DIMM not compatibleThis message applies to the 3ware 9500S controller which has removablememory. This message will be sent if there is incompatible SODIMMmemory connected to the controller. In this case, the controller is inoperableand cannot be used until a compatible SO-DIMM is put on the controller. Fora list of SODIMMs compatible with the 9500S, seehttp://www.3ware.com/KB/article.aspx?id=11748.Other 3ware controller models do not have memory that can be removed.0038 SO-DIMM not detectedThis message applies to the 3ware 9500S controller which has removablememory. This message will be sent if there is no SODIMM memoryconnected to the controller. In this case, the controller is inoperable andcannot be used until a compatible SO-DIMM is put on the controller. For a listof SODIMMs compatible with the 9500S, seehttp://www.3ware.com/KB/article.aspx?id=11748.Other 3ware controller models do not have memory that can be removed.0039 Buffer ECC error correctedThis message will be sent when the controller has detected and corrected amemory ECC error.003A Drive power on reset detectedIf the controller detects that a drive has lost power and then restarted, it willsend this message. The controller may degrade the unit (if possible).For troubleshooting information and a link to drive manufacturer diagnosticutilities, see http://www.3ware.com/KB/article.aspx?id=14927.003B Rebuild pausedThis message will be sent when the rebuild operation is paused.Rebuilds are normally paused for ten minutes after a system first boots up andduring non-scheduled times when scheduling is enabled.
