Layout example, door closedThis diagram shows a cabinet layout example with the input power cable entry from top andthe motor cable entry from bottom.1546893127Operating handle of the disconnector6Air inlet for the drive module1Rubber grommets for degree of protection7An extra fan is not necessary if an extra air baffleis used on the cabinet roof (see the following lay-out examples)2Roof air flow viewed from top8Air outlet for the drive module and LCL filtermodule and other equipment on the cabinet roof.An exhaust fan if needed.3Fan required for IP20, IP42 or IP54 air outlet kit,has to be ordered separately. See Coolingfans (page 108).9Drive control panel with DPMP-01 mounting plat-form (option +J410). The control panel is connec-ted to the drive module control unit inside thecabinet.4-Contactor control switch and emergency stopswitch (connected to the contactor control circuitinside the cabinet)5Note: The sizes of the air inlet and outlet gratings are critical for proper cooling of the drive module. For lossesand cooling data requirements, see the technical data.38 Guidelines for planning the mechanical installation
