Safety instructions11Permanent magnet motorThese are additional warnings concerning permanent magnet motor drives. Ignoringthe instructions can cause physical injury or death, or damage to the equipment.Installation and maintenance workWARNING! Do not work on the drive when the permanent magnet motor is rotating.Also, when the supply power is switched off and the inverter is stopped, a rotatingpermanent magnet motor feeds power to the intermediate circuit of the drive and thesupply connections become live.Before installation and maintenance work on the drive:ï Stop the motor.ï Ensure that the motor cannot rotate during work.ï Ensure that there is no voltage on the drive power terminals:Alternative 1) Disconnect the motor from the drive with a safety switch or by othermeans. Measure that there is no voltage present on the drive input or outputterminals (U1, V1, W1, U2, V2, W2).Alternative 2) Measure that there is no voltage present on the drive input or outputterminals (U1, V1, W1, U2, V2, W2). Ground the drive output terminalstemporarily by connecting them together as well as to the PE.Alternative 3) If possible, both of the above.Start-up and operationWARNING! Do not run the motor over the rated speed. Motor overspeed leads toovervoltage which may damage or explode the capacitors in the intermediate circuitof the drive.Controlling a permanent magnet motor is only allowed using the ACS800 PermanentMagnet Synchronous Motor Drive Application Program, or other applicationprograms in scalar control mode.
