ABB ACS800-11 Hardware Manual

Also see for ACS800-11: Hardware manual Application guide

Contents

ABB ACS800-11 Hardware Manual Manual pdf 98 page image

Technical data96ìC-tickî markingìC-tickî mark is pending as follows.ìC-tickî marking is required in Australia and New Zealand. A ìC-tickî mark is attached to each drive inorder to verify compliance with the relevant standard (IEC 61800-3 (1996) ñ Adjustable speed electricalpower drive systems ñ Part 3: EMC product standard including specific test methods), mandated by theTrans-Tasman Electromagnetic Compatibility Scheme.DefinitionsEMC stands for Electromagnetic Compatibility. It is the ability of electrical/electronic equipment tooperate without problems within an electromagnetic environment. Likewise, the equipment must notdisturb or interfere with any other product or system within its locality.The Trans-Tasman Electromagnetic Compatibility Scheme (EMCS) was introduced by the AustralianCommunication Authority (ACA) and the Radio Spectrum Management Group (RSM) of the NewZealand Ministry of Economic Development (NZMED) in November 2001. The aim of the scheme is toprotect the radiofrequency spectrum by introducing technical limits for emission from electrical/electronic products.First environment includes establishments connected to a low-voltage network which supplies buildingsused for domestic purposes.Second environment includes establishments connected to a network not supplying domestic premises.Restricted distribution: mode of sales distribution in which the manufacturer restricts the supply ofequipment to suppliers, customers or users who separately or jointly have technical competence in theEMC requirements of the application of drives.Unrestricted distribution: mode of sales distribution in which the supply of equipment is not dependenton the EMC competence of the customer or user for the application of drives.Compliance with IEC 61800-3First environment (restricted distribution)The drive complies with the limits of IEC 61800-3 with the following provisions:1. The drive is equipped with EMC filter +E202.2. The drive is installed according to the instructions given in the Hardware Manual.3. The motor and control cables used are selected as specified in the Hardware Manual.4. Maximum cable length is 100 metres.Note: The drive must not be equipped with EMC filter +E202 when installed to IT (unearthed) systems.The mains becomes connected to earth potential through the EMC filter capacitors. In IT systems thismay cause danger or damage the unit.