Technical data95Second environmentThe drive complies with the standard with the following provisions:1. The drive is equipped with EMC filter +E200. The filter is suitable for TN (earthed) networks only.2. The motor and control cables are selected as specified in the Hardware Manual.3. The drive is installed according to the instructions given in the Hardware Manual.4. Maximum cable length is 100 metres.If the above listed provisions cannot be met, e.g. the drive cannot be equipped with EMC filter +E200when installed to an IT (unearthed) network, the requirements of the EMC Directive can be met asfollows for restricted distribution:1. It is ensured that no excessive emission is propagated to neighbouring low-voltage networks. Insome cases, the natural suppression in transformers and cables is sufficient. If in doubt, a supplytransformer with static screening between the primary and secondary windings can be used.2. An EMC plan for preventing disturbances is drawn up for the installation. A template is availablefrom the local ABB representative.3. The motor and control cables are selected as specified in the Hardware Manual.4. The drive is installed according to the instructions given in the Hardware Manual.Machinery DirectiveThe drive complies with the European Union Machinery Directive (98/37/EC) requirements for anequipment intended to be incorporated into machinery.Low voltageEquipmentLow voltageEquipmentEquipment(victim)Supply transformerMedium voltage networkStatic screenPoint of measurementDriveNeighbouring network
