ABB ACS800 Hardware Manual

Also see for ACS 800 Series: User manual Hardware manual Hardware manual Hardware manual Installation guide

Contents

ABB ACS800 Hardware Manual Manual pdf 77 page image

Electrical installation69Cabling of I/O and fieldbus modulesPulse encoder module cablingShieldModule2341As short as possibleNote: The RDIO module does notinclude a terminal for cable shieldgrounding. Ground the pair cableshields here.ShieldRTAC2341Wrap copper tape around thestripped part of the cable under theclamp. Be careful. Do not cut thegrounding wire. Clamp as close tothe terminals as possible.Note1: If the encoder is of unisolated type,ground the encoder cable at the drive endonly. If the encoder is galvanically isolatedfrom the motor shaft and the stator frame,ground the encoder cable shield at the driveand the encoder end.Note 2: Twist the pair cable wires.As short as possiblePhone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com