ABB ACS800-U31 manuals
ACS800-U31
Table of contents
- ACS800 Single Drive Manuals
- What this chapter contains
- Installation and maintenance work
- Grounding
- Mechanical installation and maintenance
- Printed circuit boards
- Operation
- Permanent magnet motor
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- Contents
- Installation and commissioning flowchart
- Inquiries
- Terms
- AC voltage and current waveforms
- Main circuit and control interfaces diagram
- Fieldbus control of the line-side converter
- Connection diagram of the RMIO board in the line-side converter
- Type code
- Unpacking the unit
- Moving the unit
- Before installation
- Mounting the drive on the wall
- Preventing cooling air recirculation
- Unit above another
- Protecting the motor insulation and bearings
- Requirements table
- Permanent magnet synchronous motor
- Supply connection
- Thermal overload and short-circuit protection
- Short-circuit protection
- Ground fault protection
- Prevention of Unexpected Start
- Selecting the power cables
- Alternative power cable types
- Additional US requirements
- Equipment connected to the motor cable
- Protecting the relay output contacts and attenuating disturbances in case of inductive loads
- Selecting the control cables
- Connection of a motor temperature sensor to the drive I/O
- Control cable ducts
- IT (ungrounded) systems
- Connecting the power cables
- Conductor stripping lengths
- Wall installed units (US version)
- Warning sticker
- Connecting the control cables
- degrees grounding
- Cabling of I/O and fieldbus modules
- Fastening the control cables and covers
- Circuit diagram
- Dimensional drawing
- Note on external power supply
- External control connections (non-US)
- External control connections (US)
- RMIO board specifications
- Relay outputs
- Control panel
- To control the motor-side converter
- Parameters
- ACS800-31/U31 specific parameters in the IGBT Supply Control Program
- AUTOMATIC RESET
- Fixed parameters with the ACS800-31 and ACS800-U31
- Heatsink
- Fan replacement (R5, R6)
- Replacement (R6)
- IEC data
- Symbols
- Mains cable fuses
- Cable types
- NEMA data
- Input cable fuses
- Input power connection
- Motor connection
- Ambient conditions
- Materials
- CE marking
- Second environment (drive of category C3)
- C-tick" marking
- UL/CSA markings
- Dimensional drawings
- Frame size R5 (IP21, UL type open, UL type 1)
- Frame size R6 (IP21, UL type open, UL type 1)
- External brake chopper and resistor(s) for the ACS800-31/U31
- Brake chopper and resistor installation
- Brake circuit commissioning
- Connecting +24 V external power supply
- RMIO board of the line-side converter
manualsdatabase
Your AI-powered manual search engine