Introduction to the manual22Start-up refers to the start-up instructions of the cabinet-installed drive.Fault tracing describes the LED indications and refers to the fault tracing instructionsof the drive.Maintenance contains preventive maintenance instructions.Technical data contains the technical specifications of the drive module, eg, theratings, sizes and technical requirements, provisions for fulfilling the requirements forCE and other markings.Dimension drawings contains dimension drawings of the drive module installed intoa Rittal TS 8 cabinet.Example circuit diagram shows an example circuit diagram for a cabinet-installeddrive module.Resistor braking describes how to select, protect and wire brake resistors.du/dt filters describes how to select du/dt filters for the drive.Categorization by frame size and option codeThe instructions, technical data and dimension drawings which concern only certaindrive frame sizes are marked with the symbol of the frame size (G1 or G2). Theframe size is marked on the type designation label.The instructions and technical data which concern only certain optional selectionsare marked with option codes, eg, +H381. The options included in the drive can beidentified from the option codes visible on the type designation label. The optionselections are listed in section Type designation key on page 35.Quick installation, commissioning and operating flowchartTask SeePlan the installation.Check the ambient conditions, ratings, requiredcooling air flow, input power connection, compatibilityof the motor, motor connection, and other technicaldata.Select the cables.Planning the cabinet installation (page 37)Planning the electrical installation (page 49)Technical data (page 125)Resistor braking (page 155)Option manual (if optional equipment isincluded)Unpack and check the units.Check that all necessary optional modules andequipment are present and correct.Only intact units may be started up.Moving and unpacking the unit (page 74)Checking the delivery (page 76)If the drive module has been non-operationalfor more than one year, the converter DC linkcapacitors need to be reformed. (Reforming thecapacitors, page 124)
