Start-up 1298Start-upWhat this chapter containsThis chapter describes the start-up procedure of the drive.Startup procedure1. Run setup of the drive control program according to the start-up instructions givenin Quick start-up guide for ACS880 primary control program or in the firmwaremanual.• For drives with resistor braking (option +D151): see also section Start-up onpage 253.• For drives with ABB sine filter, check that parameter 95.15 Special HWsettings is set to ABB sine filter. For other sine filters, see Sine filterhardware manual (3AXD50000016814 [English]).• For drives with ABB motors in explosive atmospheres, see also ACS880drives with ABB motors in explosive atmospheres (3AXD50000019585[English]).2. Validate the Safe torque off function according to the instructions given in chapterSafe Torque off function on page 235.3. Validate the safety functions (option +Q973 or +Q972) as described in FSO-12safety functions module user’s manual (3AXD50000015612 [English]) or in FSO-21 safety functions module user’s manual (3AXD50000015614 [English]).
