210 Technical data Category C3The drive complies with the standard with the following provisions:1. The drive is equipped with EMC filter +E200 or +E201.2. The motor and control cables are selected as specified in the hardware manual.3. The drive is installed according to the instructions given in the hardware manual.4. Maximum motor cable length is 150 meters.WARNING! A drive of category C3 is not intended to be used on a low-voltage publicnetwork which supplies domestic premises. Radio frequency interference is expectedif the drive is used on such a network. Category C4If the provisions under Category C3 cannot be met, the requirements of the standardcan be met as follows:1. It is ensured that no excessive emission is propagated to neighboring low-voltagenetworks. In some cases, the inherent suppression in transformers and cables issufficient. If in doubt, the supply transformer with static screening between theprimary and secondary windings can be used.2. An EMC plan for preventing disturbances is drawn up for the installation. Atemplate is available from the local ABB representative.3. The motor and control cables are selected as specified in the hardware manual.4. The drive is installed according to the instructions given in the hardware manual.Low voltageEquipmentLow voltageEquipmentEquipment(victim)Supply transformerMedium voltage networkStatic screenPoint of measurementDriveNeighboring network
