ABB ACSM1-04 Series Hardware Manual

Also see for ACSM1-04 Series: Manual System manual Quick installation guide Quick installation guide

Contents

ABB ACSM1-04 Series Hardware Manual Manual pdf 80 page image

Technical data80WARNING! The drive may cause radio interference if used in a residential or domestic environment.The user is required to take measures to prevent interference, in addition to the requirements for CEcompliance listed above, if necessary.Compliance with EN 61800-3 (2004), category C3The drive meets the requirements of the EMC Directive with the following provisions:1. The motor and control cables are selected as specified in the chapter Planning the electricalinstallation.2. The drive is installed according to the instructions given in this manual.3. Motor cable length does not exceed 50 metres (164 ft).Compliance with EN 61800-3 (2004), category C4The drive meets the requirements of the EMC Directive with the following provisions:1. It is ensured that no excessive emission is propagated to neighbouring low-voltage networks. Insome cases, the natural suppression in transformers and cables is sufficient. If in doubt, a supplytransformer with static screening between the primary and secondary windings can be used.2. An EMC plan for preventing disturbances is drawn up for the installation. A template is available fromthe local ABB representative.3. The motor and control cables are selected as specified in the chapter Planning the electricalinstallation.4. The drive is installed according to the instructions given in this manual.Compliance with the Machinery DirectiveThe drive is intended to be incorporated into machinery to constitute machinery covered by MachineryDirective (98/37/EC) and does therefore not in every respect comply with the provisions of the directive.For more information, see the Declaration of Incorporation by ABB Drives (code 64652770).C-Tick markingCompliance with IEC 61800-3 (2004)See section Compliance with the European EMC Directive on page 79.Low voltageEquipmentLow voltageEquipmentEquipment(victim)Supply transformerMedium voltage networkStatic screenPoint of measurementDriveNeighbouring network