Safety instructions103ADW000462R0101 DCS880 Hardware Manual e aPrinted circuit boards and fiber optic cablesThese instructions are intended for all who handle the circuit boards and fiber opticcables. Ignoring the following instructions can cause damage to the equipment.WARNING- The printed circuit boards contain components sensitive to electrostaticdischarge. Wear a grounding wrist band when handling the boards. Do not touchthe boards unnecessarily.- Use grounding strip:ABB order no.: 3ADV050035P0001WARNING- Handle the fiber optic cables with care.- When unplugging optic cables, always grab the connector, not the cable itself.- Do not touch the ends of the fibers with bare hands as the fiber is extremelysensitive to dirt.- The minimum allowed bend radius is 35 mm (1.4 in.).Mechanical installationThese notes are intended for all who install the drive. Handle the unit carefully toavoid damage and injury.WARNING- DCS880 sizes H4 ... H8: The drive is heavy. Do not lift it alone. Do not lift the unitby the front cover. Place units H4 ... H6 only on its back.DCS880 sizes H6 ... H8: The drive is heavy. Lift the drive by the lifting lugs only.Do not tilt the unit. The unit will overturn from a tilt of about 6 degrees.- Make sure that dust from drilling does not enter the drive when installing.Electrically conductive dust inside the unit may cause damage or lead tomalfunction.- Ensure sufficient cooling.- Do not fasten the drive by riveting or welding.
