Section 11 Testing functionality by secondaryinjection11.1 Testing disturbance report11.1.1 Introduction M17101-2 v6The following sub-functions are included in the disturbance report function:• Disturbance recorder• Event list• Event recorder• Fault locator• Trip value recorder• IndicationsIf the disturbance report is set on, then its sub-functions are also set up and so it isnot possible to only switch these sub-functions off. The disturbance report functionis switched off (parameter Operation = Off) in PCM600 or the local HMI underMain menu/Settings/IED Settings/Monitoring/Disturbance report/DRPRDRE:1.11.1.2 Disturbance report settings M11746-2 v6When the IED is in test mode, the disturbance report can be made active orinactive. If the disturbance recorder is turned on during test mode, recordings willbe made. When test mode is switched off all recordings made during the testsession are cleared.Setting OpModeTest for the control of the disturbance recorder during test modeare located on the local HMI under Main menu/Settings/IED Settings/Monitoring/Disturbance report/DRPRDRE:1.11.1.3 Disturbance recorder (DR) M11750-2 v6A Manual Trig can be started at any time. This results in a recording of the actualvalues from all recorded channels.The Manual Trig can be started in two ways:1. From the local HMI under Main menu/Disturbance records.1.1. Enter on the row at the bottom of the HMI called Manual trig.1MRK 505 378-UEN A Section 11Testing functionality by secondary injectionLine differential protection RED670 2.2 IEC 103Commissioning manual
