ABB SAS-W1.1E System Manual

Also see for SAS-W1.11E: System manual

ABB SAS-W1.1E System Manual Manual pdf 37 page image

BUS C H- /AB B- S ECU R E @ HO M E2CSM 6 0072 7D0 9 01 3 7/ 56Parameter Meaning Possible valuesLabel Serves to better identify the detector. A descriptive and uniquename is recommended, e.g. KITCHEN, LIVING ROOM, BATHROOM,PORCH etc.Alphanumerical characters,maximum length 10 charac-ters.Exclude Exclude the detector (the central unit will ignore any of its alarmreports), while maintaining the configuration. Corresponds tothe Isolation function, as defined in the EN 50131-1 standard.YES, NOSupervision Select the frequency at which the central unit states that the de-tector functions.NO, 15, 45 (1)Delay (2) Delay time between alarm system arming and activation of alarmswhen leaving the protected areas, or delay time between intrusiondetection and alarm reports when a protected area is entered. Al-lows you to leave the protected areas after arming the alarm usinga command device without triggering the report or to enter theprotected areas and disarm the alarm system located within thoseareas. The entry delay time must only be applied to detectors thatcover the route between the entry point (door, garage shutter, etc.)and the command device.NO, 15, 30, 60, 90. If NO isselected, the alarm reportis immediate.(2)The underlined values are the factory settings.(1) Frequencies other than 15 minutes do not comply with regulation 50131-6 par. 4.5.1.(2) Settings based on time delays other than 0 do not comply with the EN 50131-1 and EN50131-3 regulations.(3) Subsequent amendments to parameters outside of this interval are stored on the controlpanel and received by the detector when the first useful transmission is performed: notifica-tion of this situation is provided via the icon in the top right of the display.12.3 Programming system devicesThis menu allows you to programme remote controls, sirens and repeaters.Access the Programming menu and log in as a level 3 user.12.3.1 Remote Control ProgrammingWARNING! Transmissions from the remote control to the central unit are encrypted,and have a variable code that has 65536 possible combinations for each individualcommand transmitted.Select the "system devices" icon and then "remote controls":Select “New device” and press OK1 Remote control 12 Remote control 2New Device