ABB SAS-W1.1E System Manual

Also see for SAS-W1.11E: System manual

ABB SAS-W1.1E System Manual Manual pdf 42 page image

BUS C H- /AB B- S ECU R E @ HO M E2CSM 6 0072 7D0 9 01 42 /5612.4.2 Zones FiltersAllows customised filters to be set for the siren, or the zone (or zones) where the siren is as-signed, to for the conditions to be set under which the alarm siren sounds. The options are:All zones, or a sub-set of zones.12.4.3 AlarmsAllows operating parameters such as type of sound, duration etc. of the alarm event siren tobe modified.(*) Alarms include: Away intrusion alarm, zone tampering alarm, Panic and System tamper-ing alarms if the “system tampering” parameter is set to Yes.Various parameters can be set for the various alarms. To configure the parameters of a cer-tain type of alarm, use the arrow keys to move to the corresponding one, select it and pressOK to salve.The following parameters can be modified in the window that opens:Alarm type / event Sound Frequency Burst LEDsType 1 alarms Sweep / Bitonal/NoneHigh/Low 10s/ 30 s / 3 m / 9 m ** YES / NOAlarm 2TechnologicalSweep / Bitonal/NoneHigh/Low 10s / 30 s / 3 m / 9 m YES / NOExternal Activation 1 long beep /3 short beeps / none1 long flash / 3short / NODeactivation 1 long beep / 3 shortbeeps / none1 long flash / 3short / NO(**) To ensure compliance with EN 50131 1 and EN 50131 3 standards, siren activation timemust be greater than 90 seconds and less than 15 minutes (without prejudice to local or na-tional regulations to the contrary).Factory settings are indicated in bold. To change a parameter, use the arrow keys to move toit and press the OK key to confirm the selection.WARNING!The low frequency Sweep, high frequency Bitonal and low frequency Bitonal typesounds do not comply with the EN 50131-1 standard.12.4.4 EventsAllows the siren operating parameters to be modified for alarm system arming and disarm-ing events, using a procedure similar to the previous Alarms.REACTIONS Siren1 Alarms (*)2 Technological