Chapter 2. Setting Up the Express 30002-2 Express 3000 User Manual 61203153L2-20WINDOWS INSTALLATION PROCEDUREThe following Step/Action tables provide step-by-step instructionsfor installing the Express 3000. However, the basic installation proce-dure is as follows:1. Connect and power up the hardware (see page 2-2).2. Install the Express 3000 into the operating system (see page 2-3).3. Install the Express Configuration software (see page 2-4).Connecting the Hardware: WindowsAs the first step in getting your Express 3000 up and running, installthe hardware. To ensure success, closely follow the instructions be-low—particularly those relating to installing the cables.Windows Instructions for Connecting the HardwareStep Action1 Connect the Express 3000 to the PC:With the computer’s power off and using an appropriate serialcable (this serial cable is not provided—see Table 1-1 onpage 1-3), connect the EIA-232 port on the Express 3000 toan available COM port on the computer.2 Power on the Express 3000:Plug the Express 3000 power supply cord into the port on theunit labeledPWR. Plug the other end into an electrical outlet.The Express 3000 is now powered on.3 Connect the Express 3000 to the ISDN line:Plug the large (RJ-45) end of the provided ISDN cable into thejack on the rear of the Express 3000 labeledISDN; plug thesmall (RJ-11) end of the same ISDN cable into the ISDNtelephone wall jack.4 Power on the computer.5 Insert the provided Express 3000 CD-ROM into theCD-ROM drive.
