ADTRAN 6000 Series System Manual

Also see for TRACER 6000 SERIES: User manual

Contents

ADTRAN 6000 Series System Manual Manual pdf 107 page image

612806420L1-1F Copyright © 2005 ADTRAN, Inc. 107DLP-6 Updating the Firmware Using XMODEMIntroductionThe TRACER 64x0 supports firmware updates of the local and remote systems using TFTP or XMODEM.Use the 10/100BaseT/TX MGMT port and TFTP from a network server or XMODEM (if your Telnet clientsupports file transfers), or use XMODEM and the CRAFT interface. This procedure outlines the steps for asuccessful firmware upgrade using the CRAFT interface and XMODEM software. The same XMODEMsteps apply for file transfers through your Telnet client (refer to your Telnet client documentation for moredetails on file transfer specifics). (See DLP-5, Updating the Firmware Using TFTP, on page 103 forinstructions on using TFTP.)Tools and Materials Required• VT100 terminal or PC with VT100 terminal emulation software• XMODEM softwareTo prevent electrical shock, do not install equipment in a wet location or during alightning stormElectronic equipment can be damaged by static electrical discharge. Before handling it,put on an antistatic discharge wrist strap to prevent damage to electronic components.Place equipment in antistatic packing material when transporting or storing. Whenworking on equipment, always place it on an approved antistatic mat that is electricallygrounded.