612806420L1-1F Copyright © 2005 ADTRAN, Inc. 95DLP-3 Setting IP Parameters for the TRACER 64x0IntroductionIf the TRACER 64x0 is connected to an IP network for Telnet, TFTP, or SNMP management, several IPparameters must be set for the unit to communicate with the network. These parameters are described inthis DLP along with the procedures for setting them.Prerequisite ProceduresThis procedure assumes that the TRACER 64x0 unit is connected to an IP network and is powered up.Please see your Network Administrator for the proper assignment of the followingparameters: IP ADDRESS, S UBNET MASK, and D EFAULT GATEWAY.To prevent electrical shock, do not install equipment in a wet location or during alightning storm.Electronic equipment can be damaged by static electrical discharge. Before handling it,put on an antistatic discharge wrist strap to prevent damage to electronic components.Place equipment in antistatic packing material when transporting or storing. Whenworking on equipment, always place it on an approved antistatic mat that is electricallygrounded.
