ADTRAN 6000 Series System Manual

Also see for TRACER 6000 SERIES: User manual

Contents

ADTRAN 6000 Series System Manual Manual pdf 51 page image

TRACER 6000 Series Integrated System Manual Section 4 Network Turnup Procedure612806420L1-1F Copyright © 2005 ADTRAN, Inc. 519. CONNECTING THE MODULE INTERFACESQuad T1 Module InterfacesThe physical T1 interfaces are provided using four RJ-45 ports located on the module. Straight-through T1interface cables can be used to interface to any standard T1 DTE device (not supplied).Quad Ethernet Switch ModuleThe physical Ethernet interfaces are provided using four RJ-45 jacks. Ethernet cables are not supplied withyour shipment. Connect any standard Ethernet device to one of the switch ports located on the rear of theunit.Quad E1 (120Ω) Module InterfacesThe physical E1 interfaces are provided using four RJ-45 ports located on the module. Straight-through E1interface cables can be used to interface to any standard E1 DTE device (not supplied).Quad E1 (75Ω) Module InterfacesThe physical E1 interfaces are provided using a single DB-25 interface, an adapter cable, and a BNCbreakout panel. Connect one end of the adapter cable (labeled TO RADIO) to the module’s DB-25connector, and then attach the other end of the cable (labeled TO PANEL) to the BNC breakout panel. The75Ω unbalanced interfaces provided by the breakout panel are available for connection to standard E1DTE devices (see Figure 6 on page 52).Instructions for Installing Network Modules1. Remove power from the unit.2. Remove the blank panel plate (if necessary).3. Slide the network module into the network slot until the module is firmly seatedagainst the front of the chassis.4. Secure the screws at both edges of the module.5. Install the optional hardware components (when necessary). For example, forthe E1 network module, an optional BNC breakout panel is available.6. Connect the cables to the associated device(s).7. Restore power to the unit.T1 crossover cables are needed when connecting two TRACER 64x0 T1 ports inback-to-back operation.E1 crossover cables are needed when connecting two TRACER 64x0 E1 ports inback-to-back operation.