ADTRAN 6000 Series System Manual

Also see for TRACER 6000 SERIES: User manual

Contents

ADTRAN 6000 Series System Manual Manual pdf 44 page image

Section 4 Network Turnup Procedure TRACER 6000 Series Integrated System Manual44 Copyright © 2005 ADTRAN, Inc. 612806420L1-1F1. INTRODUCTIONThis section discusses TRACER 64x0 system installation.2. TOOLS REQUIREDThe tools required for TRACER 64x0 installation are:• VT100 terminal or PC with terminal emulation software• RS-232 (DB-9 male for TRACER 64x0) cable for connecting to terminal3. UNPACK AND INSPECT THE SYSTEMEach TRACER 64x0 is shipped in its own cardboard shipping carton. Open each carton carefully andavoid deep penetration into the carton with sharp objects.After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged intransit, immediately file a claim with the carrier; then contact ADTRAN Customer Service (see Warranty,Customer Service, Product Support Information, and Training information in the front of this manual).Contents of ShipmentYour shipment of the base unit includes the following items:• TRACER 64x0 unit• RJ-45 to DB-9 connector (ADTRAN P/N 3196ADPT001) for connection to the AUX RS232 port• 6-foot silver satin cable for connection to the AUX RS232 port• Rackmount brackets• Power and Alarm connectors• Spare fuse• ADTRAN received signal power versus RSSI reference sheet• TRACER 64x0 Documentation CDChanges or modifications not expressly approved by ADTRAN could void the user’sauthority to operate the equipment.To prevent electrical shock, do not install equipment in a wet location or during a lightningstorm.This system MUST be installed by qualified service personnel in a Restricted AccessLocation.