Team Functions Programming the Call Keys90Holding and Transferring Calls with a Feature KeyUsing the “Hold” function, team members can accept a call that has been parkedby another team member. To use the “Hold” function, it must be programmed toan unused feature key on the team members’ telephones.For information on how to programme the feature keys, please refer to the chapterentitled Programming Functions (Features) starting on page 123.4.2 Programming the Call KeysThe call keys are configured in the Configurator on the OpenCom 100 Webconsole. For system telephones, you can configure the following:■ the type of key (trunk key, team key, busy key or direct-call key),■ the call number and the text currently assigned to the key,■ the call signalling mode for this key.You can change the pre-settings for the text and the call signalling mode on theappropriate key’s MenuCard (see the following sections: MenuCard “Prog. call key”(Trunk Key) on page 91, MenuCard “Prog. team key” on page 92, and MenuCard“Prog. busy key” on page 93) as well as most of the settings for supported features.G You are speaking via a call key, e. g. the trunk key with thecall number 11.g h Press the “Hold” feature key to put the call on hold. Put thehandset on the hook.On the team telephones with the call number 11 pro-grammed on a trunk key or a team key, the LED for the pro-grammed key flashes. The display indicates that a call for thecall number 11 is put on hold (is parked).g Accepting Calls with a Team Key: Another team memberpresses the team key to which the call number 11 has beenassigned.g Accepting Calls with a Trunk Key: Another team memberpresses the trunk key to which the call number 11 has beenassigned.
