Remote-controlled Functions Remote-Programmable Voicebox Configuration and Query96Using the call number reserved in the OpenCom 100 for remote control, you canconfigure or delete call forwarding “Immediate” for your own call number froma remote location. This remotely-programmed forwarding overwrites any otherexisting call forwarding. Call forwarding “On Busy” and “After Delay” are notaffected. Incorrect or non-existent call numbers are rejected. Your authorisation ischecked in the same way as for call forwarding within the OpenCom 100.A correct entry is confirmed with a positive acknowledgement signal, providedthe system administrator has not deactivated this function (in the Configurator,PBX Configuration: System: Settings menu). The external call is subsequentlyended.Note: The procedure is aborted if there is a pause of longerthan 60 seconds between the entry of two digits. With thisduration, remote-controlled functions using GSM cell phonescan also be realised.5.3 Remote-Programmable Voicebox Configurationand QueryIf the system administrator has configured remote query authorisation for yourvoicebox, you can query and configure your voicebox from an external telephone:■ Using the call number of OpenVoice (this number is included in the incomingcall distribution) …you dial the MSN or the system number assigned by the system administratorto the internal number of OpenVoice.■ Using your own call number (this number is included in the incoming call dis-tribution, and you have activated call forwarding for this telephone to thevoicebox) …you dial the MSN or the direct-dialling in number under which you can bereached by external callers.Z Enter the system PIN.* Press the star key.Z Enter your internal call number.# Press the hash key.
