Control of Alarmed Conditions MonitoringML700 User Manual 13-9Configuring Fault Notification Sound EffectsMetaASSIST View provides user configurable sound effects that when enabled, areautomatically applied for each ML device alarm report notification. For more information onthe notification levels, refer to About Alarm Severity and Conditions (on page 13-8).MetaASSIST View runs configurable *.WAV format files for a configurable time period of 1to 10 seconds. Files longer than this time period are abruptly cut down and files shorter thanthis time period are repeated until the time runs out.NOTE: In case of a new alarm report arriving while a previously arrived alarm report tune is beingplayed - the new alarm will not be played at all unless the new alarm report is of a higher hierarchy,which then will interrupt the current tune and play the configured tune of the new arriving alarm.The sound files can be selected from a default list of files and played prior to activation. Thefile list can be modified as necessary. To configure sound effects:1. On the Tools menu, select Sound Effects. The Sound Effects dialog appears.2. To enable the audio file, select the Enable check box next to the appropriate alarmseverity.3. From the Duration list box, select the time duration (1-10 seconds).4. In the Audio File box, type the .WAV file location or locate it by clicking the Browsebutton.5. To listen to the audio file, in the dialog box, click the play button:6. For additional alarm severities, repeat steps 2 to 6.7. Click OK.
