5-7Installing the Software Driver for Novell NetWare18 Remove the disk from your floppy disk drive.19 Select Continue.20 Follow the procedures in your NetWare documentation tocomplete the installation.21 When installation is complete, restart the system.22 At the DOS prompt (c:\), change to thec:\nwserver directoryand enterserver23 At this point, install Adaptec CI/O Management Softwarefrom the server console. Refer to the Adaptec CI/O ManagementSoftware User’s Guide for instructions on installing and usingthe software.Installing the Driver When NetWare is Already InstalledTo update or install thecda1000h.ham driver if NetWare is alreadyinstalled, follow the instructions below for the version of NetWareyou have installed.NetWare 4.11 and 4.21 Copy thecda1000h.ham file from the Adaptec Array1000U2Family Manager Set driver disk into the server’s startup direc-tory (e.g.,c:\nwserver) on your hard disk.Note: For NetWare 4.11, thecda1000h.ham file is ina:\netware\v4_1x. For NetWare 4.2, thecda1000h.hamfile is ina:\netware.2 If necessary, modify the load command line in thestartup.ncfso that the proper path to the driver is specified. The correctsyntax to load thecda1000h.ham driver isload [pathname]cda1000
