5-107container Commandscontainer set labelTo assign a new label to the specified array or to assign a label to anarray that has no label, use the container set label command.The following commands have a /label switch that allows you toassign a label to the array when you create it: container create mstripe (a multilevel stripe set) container create mvolume (a multilevel volume set) container create raid5 (a RAID-5 set) container create stripe (a stripe set) container create volume (a volume set)The label you specify with the container set label commandand the /label switch associated with the previously listedcontainer create commands is not the label that displays inWindows Explorer. The label displayed by Windows Explorer comesfrom the label specified with the container format command.Syntaxcontainer set label {container} {string}Parameters{container}Specifies the ID number (0 to 63) of the array to which youwant to assign a label.{string}Specifies the label you want to assign to the array. The label is astring of up to sixteen characters.ExamplesBefore assigning a label to a specific array, use the containerlist command to obtain information about any existing arrays.As the following example shows, there is an array 0 (a volume set)on this controller with no label assigned to it (as evidenced by nolabel in the Num Label column):AAC0>container list
