5-12container CommandsDr Label Type Size Ctr Size Usage C:ID:L Offset:Size-- ----- ------ ------ --- ------ ------- ------ -------------F: 0 Volume 30M NTFS63 Mirror 15MB 0:02:0 64.0KB: 15.0MB0:04:0 64.0KB: 15.0MB62 Mirror 15MB 0:03:0 64.0KB: 15.0MB0:05:0 64.0KB: 15.0MBThe following list describes the change to the display as the result ofcreating a multilevel array of mirror sets with the containercreate mmirror command: The Dr column is blank to indicate that the newly createdmirror sets (63 and 62) do not have a drive letter assigned tothem. The Type column displays Mirror for arrays 63 and 62 toindicate that the underlying arrays are mirror sets. The State column displays the state of the arrays, which in thisexample are all in the Normal state.Note that this column appears only if you specify the /fullswitch with the container list command. The Scsi C:ID:L column displays the SCSI device ID for thedisk(s) on which the underlying mirror set(s) reside. In theexample, mirror set 63 resides on disk 0:02:0 and 0:04:0. Mirrorset 62 resides on disk 0:03:0 and 0:05:0. The Partition Offset:Size column displays the partitionoffset(s) and size(s) for the underlying mirror set(s). In theexample mirror set 63 and 62 have partition offsets of 64.0 KBand sizes of 15.0 MB.If a partition is dead, the “:” (colon) in the Partition Offset:Sizecolumn changes to a “!” (exclamation point). See the diskremove dead_partitions (page 7-9) command formore information on dead partitions.Related Informationcontainer commands: container create mirror (page 5-5) container list (page 5-54) container promote (page 5-69)
