35LED goes out and you are returned to your current Preset and live mix.In the current Preset, you will now see all Channel LEDs associatedwith a Group light whenever you press a Channel button that isincluded in your saved Group. The Channels now behave as one.Note: Remember to save the Preset if you want to be able torecall the Preset with the new Group settings later.Creating Additional GroupsThree Groups can be created and saved in each Preset in a PersonalMixer. Each Group can be created and/or edited as needed while liveaudio is playing through the system. Remember that when using theA-16CS the data is stored in the A-16R, not in the A-16CS itself.The instructions in the previous section describe how to create andsave the first Group in a mix. Creating additional Groups follows thesame procedure.Use these steps to create a second and/or third Group.• Select a Channel that is not currently part of an existingGroup.• Press the G ROUP button to enter Group Mode. TheGroup LED will flash.• Double-click any Channels that you want to add to thenew Group.• To save the Group, press the G ROUP button again to exitGroup Mode. The flashing LED will go out.Shortcut: While in the Group edit mode, you can start the process ofcreating a new Group while editing an existing Group. To do this,• Press a Channel button that is not already part of thecurrent Group being edited. Its red LED will light solid.• Double-click Channels to add them to a new Group.• Create a third Group by following the same procedure.• Exit the Group edit mode to save the Groups.• Save the Preset.If you try to create more than three Groups, the interface willautomatically select one of the existing Groups when you enter Groupedit mode. You have the option at this point to edit an existing Groupor clear Channels that are part of one of the other existing Groups.Note: A Channel that is already part of one Group cannot be partof any other Group.