Adding Printers in NetWare42 AXIS 5400+ / AXIS 5600+ User’s ManualSection 6 Adding Printers in NetWareThis section describes how to continue the installation of the AXIS5400+/AXIS 5600+ in the NetWare environment. Identify which transportprotocol you are running on your network and which installation methodyou should use. Continue the installation by selecting the appropriateinstalling instructions from the table below:See “NetWare Administration” on page 66 for information on Novell’sadministration tools.If you intend to operate your AXIS 5400+/AXIS 5600+ in a multi-protocol, mixed environment, you should also proceed to the otherrelevant sections in this manual.InstallationmethodTransportprotocol ActionNDPS TCP/IPIPX/SPXSee “Setup using NDPS” on page 43 and“Public Access Printers” on page 44“Controlled Access Printers” on page 48iPrintiPrint over LPRSee “Setup using iPrint” on page 57 and“Install a printer using AXIS LPR Gateway Configuration Snap-in”on page 59iPrint over IPPSee “Setup using iPrint” on page 57 and“Install a printer with AXIS IPP Gateway Configuration Snap-in”on page 59Queue-basedprintingIPX/SPXBasicConfigurationTo install using the AXIS NetPilot Installation Wizard,see “Basic Setup with AXIS NetPilot” on page 61IPX/SPXAdvancedconfigurationIf you need a more advanced installation that is not covered bythe AXIS NetPilot Installation Wizard, see“Advanced Installation using AXIS NetPilot” on page 62
