Management and Configuration AXIS 5400/AXIS 5600 User’s Guide26Using the Test ButtonThe following operations can be performed by pressing the test button in differentsequences. Please refer to Product Overview, on page 5, to identify the location of thetest button.Printing a test page:• Press the test button once to print a test page.Printing the parameter list:• Press the test button twice to print the parameter list.Resetting the AXIS 5400/AXIS 5600 parameters to the factory default settings:1. Remove the external power supply to switch off the AXIS 5400/AXIS 5600.2. Press and hold down the test button, while you reconnect the external powersupply. Continue to hold down the test button until the network indicator startsto flash at one second intervals. This should take about 5 seconds.3. Release the test button and wait until the network indicator flashes at least fivetimes.4. Press and hold down the test button again until the network indicator remainsconstantly lit.5. Restart the AXIS 5400/AXIS 5600 by disconnecting and reconnecting theexternal power supply.Note:Please refer to the User’s Manual for more information about the test button.All parameters except the node address (NODE_ADDR.), the IP address (IP_ADDR.) and DHCPenabled or disabled (DHCP_ENABLE.) are reset.NetWareUNIX WindowsOS/2Macintosh