Configuration Possibilities112 AXIS 5400+ / AXIS 5600+ User’s ManualDisabling Protocols To further increase security, you must disable protocols that areconsidered insecure;• FTP (also used by AXIS ThinWizard. Note that if FTP is disabled, AXISThinWizard can not function properly.)• Telnet• Auto-IP• DHCP• BOOTP• Remote Config (used by AXIS NetPilot)• SNMP Configuration (also used by AXIS ThinWizard. Note that if SNMPis disabled, AXIS ThinWizard can not function properly.)To disable these protocols, go to Admin | Security Settings | ProtocolSettings | Detailed View and mark the check boxes. Click OK to finish.Only enabled protocols will be visible from this view!To enable these protocols, select Admin | Network Settings | DetailedView | TCP/IP Network for FTP, Telnet, AutoIP, DHCP and BOOTP.Remote Config is enabled via Admin | General Settings | RConfigSupport.Important:CheckingSSL/TLS StatusTo check SSL/TLS status, open the print server’s Web interface and selectAdmin | Network Settings | Detailed View | TCP/IP Network to see if theHTTPS Enabled parameter is set to Yes or No.To View a Certificate To view a Certificate, open the print server’s Web interface, select Admin| Security Settings and click View next to the Certificate.To Delete a Certificate To delete a Certificate, open the print server’s Web interface, select Admin| Security Settings and click Delete next to the Certificate.Enabling the SNMPv3 ProtocolInvoke the print server’s Web interface to enable the SNMPv3 protocol.To ensure maximum security, it is highly recommended that you change your Administratorpassword after generating a certificate and disabling insecure protocols! This is done fromAdmin | General Settings | Change => | General | Root Password.
