Adding Printers in NetWareAXIS 5500 / AXIS 5550 User’s Manual 51Section 7 Adding Printers in NetWareThis section describes how to continue the installation of the AXIS 5500/AXIS5550 in a NetWare environment. Identify which transport protocol you arerunning on your network and which installation method you should use.Continue the installation by selecting the appropriate installing instructionsfrom the table below:If you wish to print using iPrint, the following Axis snap-in tools are availablefrom www.axis.com (Support | Select Software):• AXIS LPR Gateway Comfiguration Snap-in for i-Print in NetWare5.x/NetWare 6.x• AXIS IPP Gateway Comfiguration Snap-in for i-Print in NetWare 5.xSee the read-me files on the web for installation instructions.If you intend to use the print server in a multi-protocol environment, refer tothe chapters pertaining to the respective operating systems in this manual.InstallationmethodTransportprotocol ActionNDPS TCP/IPIPX/SPXSee “Setup using NDPS” on page 52Proceed with “Installing the AXIS 5500/AXIS 5550 in an NDPS en-vironment” on page 52PrinterConfigurationmethodTransportprotocol ActionPSERVER mode IP/IPXSee “Setup using Queue-based Printing over IP/IPX in PSERVERMode” on page 53 and then“Overview: Queue-based Printing Methods” on page 56Remote Printermode IPX/SPXSee “Setup for Queue-based Printing over IPX/SPX (Remote PrinterMode)” on page 55 and then“Overview: Queue-based Printing Methods” on page 56
