NetWareUNIX OS/2MacintoshAXIS 560/660 User’s Manual Appendix A: Test Button 151WindowsAppendix A Test ButtonThe test button is located on the front right hand side of the AXIS560/660 and is used for:• Printing a test page, checking the connection to the printer.• Printing a parameter list, showing the AXIS 560/660 current set-tings.• Resetting the AXIS 560/660 parameters to the factory defaultsettings.The Test Page Press the test button once to print a test page. If the test page prints,the parallel interface is functioning correctly. The printed Test Pagecontains basic information about the AXIS 560/660. It isrecommended that you print a test page every time you haveconnected the AXIS 560/660 to a printer.Note: ❏ The test page is printed on LPT1 by default. If you want to printthe test page on LPT2 or COM1 instead, you should set theInternal Printout Destination parameter to LPT2 respectivelyCOM1.The Parameter List Press the test button twice to print a parameter list showing thecurrent AXIS 560/660 settings. This list provides comprehensivedetails of all the parameters and their current status. Refer toB - The Parameter List, on page 153.If you want to change any of the parameters, use one of the methodsthat are described inSection 9 Management & Configuration, on page 108.Note: ❏ The parameter list is printed on LPT1 by default. If you want toprint the parameter list on LPT2 or COM1 instead, you shouldset the Internal Printout Destination parameter to LPT2respectively COM1.
