Initial operation DUODMX GATEWAY14 BAB TECHNOLOGIE GmbH DUODMX GATEWAY4.2 DMX-CONFIGURATOR UPDATEIf you want to install a newer version of the DMX-Configurator, it is important that you correctly uninstallthe previous version beforehand. To this end, you must go toStart > System control > Programs andFunctions (Software in Windows XP) and uninstall theDMX-Configurator. Select the new setup file nowand proceed as described above.4.3 FACTORY SETTINGSThe DUODMX GATEWAY is supplied with the following factory settings: IP address: 192.168.1.223 Subnet mask: 255.255.255.0 Device name: MAC address of the device Physical KNX address: 15.15.255 Multicast address KNXnet/IP (“routing”):224.0.23.12(can be changed as of firmware version 2.2.0.0) EIBPORT system ID: 0(cannot be changed)In addition to the firmware, there is also a DMX-Configurator sample project in the installation registryof the DMX-Configurator software. If necessary, it can be used to overwrite the loaded project in theDUODMX GATEWAY.4.4 INITIAL COMMISSIONINGAs a first step, connect a conventional 12-32V power supply (DC) to the appropriate pluggable screwterminals or to a PoE network connection (Figure 3) and connect the DUODMX GATEWAY to thenetwork. The green power LED is continuously on once the device has been started.The second step is the configuration of the network settings.For configuration, the PC must be in the same IP address range as the DUODMX GATEWAY.If it is not possible to change the network settings of the PC, you can alternatively transfer thenetwork settings by means of an SD card. Start the DMX-Configurator and switch to the menu screenExtensions – DUO-DMX GATEWAY.Figure 7: DMX-Configurator – extensions
