Programming DUODMX GATEWAY42 BAB TECHNOLOGIE GmbH DUODMX GATEWAY5.5.2.3 LAN/KNXThe settings specific for the network and for KNX are made in theLAN/KNX tab.IMPORTANT NOTICE: In case that DUO DMX cannot be found, you must deactivate all networkinterfaces except for the currently used network interface!Figure 39: KNX DUODMX GATEWAY1. Activating/deactivating DHCP2. IP address setting and KNXnet/IP (routing) multicast group.3. List of the DUODMX GATEWAYs available in the network. Is reloaded by pressing theSearchbutton. The corresponding gateway is indicated together with its IP address, the assigned nameand the current firmware version number (as of firmware 2.0.0.1). If the device has not yet beenassigned a name, its MAC address is indicated. With a mouse click, you can mark a device for theconfiguration data upload or the activation of the unicast preview.4. Press theSearch button to show all DUODMX GATEWAYS available in the network. Once thedesired device has been marked in the list and theUpload button has been pressed, all currentconfiguration data are transmitted to the device via the network (PC and DUODMX GATEWAYmust be in the same IP address range).5. You can specify at this point, for which of the both DMX interfaces you want to enable thepreview. The preview is not enabled until you have ticked the check box (broadcast preview). If adevice is also marked in theDMX Gateways list, the preview is only applicable to this device(unicast preview). In this case, the PC and the gateway must be in the same network range(subnet). (See also chapter“Enabling the DMX preview”).68134527
