DUODMX GATEWAYDUODMX GATEWAY BAB TECHNOLOGIE GmbH 93 ASSEMBLY3.1 CEILING INSTALLATION VARIANTThe device can be used for ceiling installation but also for DIN rail assembly. For ceiling installation, thedevice is equipped with fastening lugs at two sides.For DIN rail assembly, an adapter can be provided as an option. The fastening lugs are designed so thatthey can be dismantled on demand.Figure 1: DUODMX GATEWAY with lugsDIN rail adapterThe adapter is mounted to the housing with two screws included in the scope of supply. Make sure thatthe adapter is screwed to the housing through the two grooved holes only. These two holes are markedby the red circles on the picture.Figure 2: DIN rail adapterNote: Please use the two marked holes if you assemble the DIN rail adapter to the DUODMXGATEWAY. If you do not use the correct holes, the screw ends may touch the bottom side of thecircuit board!Please be careful if you want to loosen a device mounted on the DIN rail from the rail. If you applyexcessive force when removing the gateway, the screws of the adapter might be ripped out from thehousing.
