MAKING EMBROIDERY ADJUSTMENTSE-32■ Bobbin Thread is Too TightUpper thread on the right side of fabric seems to belifting/looping and bobbin thread is not seen on thewrong side of fabric.a Right sideb Wrong sideIf this occurs, turn the slotted-head screw (-)counterclockwise, being careful not to over-loosenthe screw, approximately 30-45 degrees to decreasebobbin tension.Using the Automatic ThreadCutting Function(END COLOR TRIM)The automatic thread cutting function will cutthe thread at the end of sewing each color. Thisfunction is initially turned on. To turn this functionoff, press key and then . This function canbe turned on or off during embroidering.* This setting returns to its defaultwhen the machine is turned off.a Press .b Press to turn off the automatic threadcutting function.→ The key will display as* When one color thread is sewn, the machine willstop without cutting the thread.Using the Thread TrimmingFunction (JUMP STITCH TRIM)The thread trimming function willautomatically trim any excess thread jumps withinthe color. This function is initially turned on. Toturn this function off, press key and then. This function can be turned on or off duringembroidering.* Your customized setting remains after turning themachine off and on.a Jump stitchCAUTION• When adjusting the bobbin case, be sure toremove the bobbin from the bobbin case.• DO NOT adjust the position of the phillips (+)screw on the bobbin case as this may result indamage to the bobbin case, rendering itunusable.• If the slotted-head screw (-) is difficult to turn,do not use force. Turning the screw too muchor providing force in either (rotational)direction may cause damage to the bobbincase. Should damage occur, the bobbin casemay not maintain proper tension.
