Barco Data 1209s Installation Manual

Also see for BarcoData 1209S: Owner's manual Owner's manual

Projector set-up5-2 5975718 BARCODATA 1209s 05069809Addressable with RCUAddressable with PC, MACor workstation255Setting the projector addressThe projector's address may be set to any value between 0 and 255.When the address is set, the projector can be controlled now by :ρ the RCU for addresses between 0 and 9.ρ a IBM PC (or compatible) or Apple MAC for addresses between 0and 255.1 1282 643 324 165 86 47 28 1Setting the address is a hardware SET-UP of your projector whichmust be done during installation. Use the 8 DIP switches provided onthe controller board labelled 'Projector Address'.Each DIP switch has its own decimal value. The sum of the valuesassociated to those DIP switches gives the address. As shown inthe table, if Switch No. 1 is set to ON, it represents a decimal valueof 128, Switch No.2 for 64, Switch No.3 for 32, and so forth.In the given example, the projector address is set to 202 :DIP switch No. : 1 2 3 4 5 6 7 8Position ON/OFF : 1 1 0 0 1 0 1 0Sum : 1x128 + 1x64 + 0x32 + 0x16 + 1x8 + 0x4 + 1x2 + 0x1 = 202Factory preset address = 0Note :When the address button on the RCU is pressed, the projector willdisplay its own address on the screen. Once the address button ispressed, to continue using your RCU, it is necessary to enter anaddress, even when the displayed address is correct. Use thenumeric keys to enter the address.For more information, please refer to the Owner's Manual of thisprojector.123456780 1OFF ONSwitch No ValuePROJECTORADDRESS001All manuals and user guides at all-guides.com