Barco Data 1209s Installation Manual

Also see for BarcoData 1209S: Owner's manual Owner's manual

AC power connection6-2 5975718 BARCODATA 1209s 050698AC Power checkCheck the power voltage which is determined by the Art. No. on theindentification label pasted on the backside of the projector.Projectors with the Art. No. R9002250 must be connected to a 230VAC power source.Projectors with the Art. No. R9002259 must be connected to a 120VAC power source.When the power voltage is different from that of the wall outlet,proceed to AC Input power voltage adaptation of the projector.AC Input power (mains) voltage adaptationAttention !The BARCODATA 1209s - R9002250 leaves the factory to operateon a mains (power) input of 230 Vac.The BARCODATA 1209s - R9002259 leaves the factory to operateon a mains (power) input of 120 Vac.Adaptation of the power input of the projector between 230 Vac and120Vac or vice versa is possible.Follow the procedure as described below to adapt the voltage :WARNING: turn off the projector and be sure the AC Power Cordis unplugged from the wall outlet before starting the procedure !- Open the top cover (see 'Access to controls' on p.4-1).- Unscrew the retaining screws of the power input protection plate.- Remove the power input protection by sliding it a little backwardsand lifting it up.Retaining screws− Pull out the 'Power selector plug' and re-insert it as illustrated indrawing, depending on the AC power of the wall outlet in the room.− Pull out the fuses and place the correct fuses in their sockets. Seethe table below for the correct fuses.230V 120V230V operation 120V operation2xT5A/250V 2xT10A/250V- Re-install the protection plate. Insert the plate until the pins fit intothe grooves of the bottom plate. The right side of the plate mustbe pushed behind the metal frame. The notch fits around the bolt.Secure the correct position by turning in the 3 screws.All manuals and user guides at all-guides.comall-guides.com