ConnectionsR5975809 BARCO CINE 6 ___________________________________________________________________________________ 3-13 CONNECTIONSPower (mains) cord connectionUse the supplied power cord to connect your projector to the wall outlet. Plug the female power connector into the male connectoron the rear of the projector.Switching on/offThe projector is switched ON and OFF using the power (mains) switch ON/OFF.Pressed : ONNot pressed : OFFThe projector can start now in the 'operational mode' (image displayed) or in the 'stand by mode', depending on the softwaresetting in the service menu of the projector . This is done during installation by a qualified technician. If you want to changethis start up mode, call a qualified technician.Stand by indication lamp :No light up : Projector in operational modeRed : Projector is in stand by.Leds on the rear plate of the projectorSignal input connection to the projector :- Composite Video- S-Video- RGB- YUV (component input)Note : All sync types accepted and Muse HDTV Standard accepted.* Input signal Y/C (luma/chroma)On RGB/YUV/Gs/H,V sep /Gs /CS on both Pol acceptedConnecting a Composite Video sourceComposite video signals from a VCR, OFF air signal, decoder, etc.1234123412341234TV TunerV C RAudioAmplifierCompositeVideoSTDBY / NORMALPAUSECOINCIDENCEEHT HOLDOWNIR RECVDSource No Projector input Press digit1 Comp. Video 12 S-Video* 23 RGB/15K/32K 34 HDTV(Gs) 4Muse5 YUV 56 YUV on HDTV 6