Connections3 - 4 ___________________________________________________________________________________ R5975809 BARCO CINE 6To select the tuner option : (only when tuner card is added)a. Press the STAR key on the RCU to activate the tuner modeORb. With the local keypad :- Press ADJUST key to display the GENERAL ACCESS menu on the screen.- Use the control keys to highlight 'TUNER'.- Press ENTER to activate the tuner mode.Peripheral equipmentConnecting a RCVDS 05 switcher to the projector.- Up to 10 inputs (20 inputs when video and S-Video) with the RCVDS 05 switcher and up to 90 inputs when 10 RCVDSswitchers are linked via the expansion modules.- Serial communication with the projector.- Remote control buttons on the RCVDS to control the projector (source selection and analog settings).- The selected source number will be displayed on a 2 digit display and the selected input modules will be indicated witha LED on the rear.For more information about the use of the RCVDS 05, consult the Owner's Manual, Order No. R5975765.Connecting a VS05 switcher to the projector.The VS05 can switch up to 5 Composite Video sources, 3 S-Video sources and 1 RGB analog or component video source tothe projector. In addition, the audio signal from the source can be switched to an audio amplifier. Order No. R9827890.For more information about the use of the VS05, consult the Owner's Manual, Order No. R5975245.Connecting an IR Remote Receiver to the Projector.This infra-red receiver makes it possible to control the projector from another room. There is a communication cable between theIR receiver and the projector or the RCVDS. The infrared control information from the RCU is sent to the IR Remote Receiver. TheIR Remote Receiver 800 displays the selected source on a 7-segment display. Order No. R9827515.GENERAL ACCESS5 63 41 2TUNEREnter ADJUSTSelect with orthen to returnBRIGHTNESSCONTRAST