R5911443 /02 UDM768.1 Configuring the lens, optical zoom-focusWhat can be done?Once a lens has been installed in the projector, you can fine-tune the projected image.Zoom - Focus1. In the main menu, select Installation → Lens → Zoom focus.Image 8-1: Lens menu, Focus & Zoom2. Use the ▲ or ▼ key to zoom the lens in or out.Use the ◄ or ► key to focus the lens to far or near.Image 8-2: Zoom and focus adjustment8.2 Configuring the lens, shiftWhat can be done?The image can be optically shifted by using the vertical and horizontal lens shift.If you want to reach a lens shift beyond what is possible with the optical shift, you can also perform a digitallens shift. This digital shift will occur on the DMD, rather than the lens holder. So take into account that thisadditional shift is minimal and restricted to the limits of the chip used.For the digital zoom and shift, navigate to Home → Image → Digital Zoom Shift.Optical lens shift is only possible when the used lens has been fully calibrated. To calibrate the lens,navigate to System Settings → Maintenance → Lens Calibration.Vertical and Horizontal Shift1. In the main menu, select Installation → Lens → Shift.GUI – Installation
