Configuring the Camera4-2 Basler A500kPRELIMINARY4.1 Configuring the Camera with the CameraConfiguration Tool Plus (CCT+)The camera configuration tool CCT+ is a Windows™ based program used to easily change thecamera’s settings. The tool communicates via the RS-644 serial connection in the Camera Linkinterface between the frame grabber and the camera. The tool automatically generates the binaryprogramming commands that are described in section 4.2. For instructions on installing the tool,see the installation booklet that was shipped with the camera.This manual assumes that you are familiar with Microsoft Windows and that you have a basicknowledge of how to use programs. Otherwise, refer to your Microsoft Windows manual.4.1.1 Opening the Configuration Tool1. Make sure that the properties for the RS-644 serial port on your frame grabber are properlyconfigured and that the camera has power.2. To start the CCT+, click Start, click Basler Vision Technologies, and then click CCT+(default installation).During start-up, a start-up screen can be seen.If start-up is successful, the tool will open. To familiarize yourself with using the tool, press theF1 key and look through the online help included with the tool.If an error occurs, the tool is automatically closed after start-up. Refer to the CCT+ InstallationGuide for possible causes.4.1.2 Closing the Configuration ToolClose the CCT+ by clicking on the button in the upper right corner of the window.
