Configuring the CameraBasler A500k 4-27PRELIMINARY4.2.7 Commands for Manipulating Configuration Sets4.2.7.1 Copy the Factory Set or the User Set into the Work Set(Profile Load)Purpose: To copy the Factory Set or one of the 15 User Sets into the Work Set. See section 3.13 for anexplanation of configuration sets.The write command will cause the selected set to be copied into the Work Set and the setwill become active immediately. Write commands greater than 0x0F will be ignored.The read command returns the ID of the set that was last copied into the Work Set. (If nothinghas been copied to the Work Set since the last power up or reset, the read command willreturn the ID for “no active set.” This condition indicates that no valid Factory Set or User Setswere found. It will also cause the orange LED on the back of the camera to show six flashes.)Type: This is a read or write command.Read Command: Cmd-ID R/W-Flag Data Length Data0x45 1 1 -Response: Cmd-ID R/W-Flag Data Length Data0x45 0 1 1 ByteWrite Command: Cmd-ID R/W-Flag Data Length Data0x45 0 1 1 ByteResponse: NoneData Format: Byte 1 An ID that specifies the set.(see the table below).Set ID Set0x00 Factory Set0x01 User Set 10x02 User Set 20x03 User Set 30x04 User Set 40x05 User Set 50x06 User Set 60x07 User Set 70x08 User Set 80x09 User Set 90x0A User Set 100x0B User Set 110x0C User Set 120x0D User Set 130x0E User Set 140x0F User Set 150xFF No active set
